336
National Instruments • T
el: (800) 433-3488
•
Fax: (512) 683-9300
•
[email protected] •
ni.com
Digital I/O Devices
Measurements
Overview
The NI 6503 devices are 24-bit parallel digital I/O interfaces
for computers with PCI, USB, PCMCIA, or ISA buses. The
NI 6507/NI 6508 families are 96-bit parallel digital I/O devices for
computers with PCI, PXI/CompactPCI, USB, or ISA buses. All
NI 650x devices are for 5 V TTL/CMOS I/O signals. For higher-
voltage signals, see page 486 for digital signal conditioning
solutions or consider the NI 6527 devices on page 334.
Hardware
82C55 Parallel Port Interfaces
The NI 650x digital I/O devices use the 82C55 Parallel Port
Interfaces (PPIs). The NI 6503 devices contain one PPI, and the
NI 6507/NI 6508 devices contain four PPIs. Each PPI controls
24 bits of digital I/O and has three 8-bit ports (A, B, and C), which
you can program as either inputs or outputs. Ports A and B are
always used for digital I/O, while port C can be configured for
digital data I/O, control, status, or handshake signals.
Digital I/O Power-Up
State Selection
You can power up the PCI-6503,
PC-DIO-24, PC-DIO-96, PXI-6508, and
DAQPad-650x digital I/O lines in a
user-defined state – either high or low. On these devices, each
line is connected to a 100 kΩ resistor and you can use a jumper
to select whether the lines of the device power up in the high or
low state. The DAQCard-DIO-24 and PCI-DIO-96 have 100 kΩ
resistors that always pull high.
• 24 or 96 digital input/output lines
• 5 V TTL/CMOS
• 2-wire handshake capability
• Known power-up states
• Available for PCI, PXI/CompactPCI,
ISA, USB, and PCMCIA
• NI-DAQ driver simplifies
configuration and measurements
Models
• NI 6503
- PCI-6503
- DAQCard-DIO-24
- PC-DIO-24
• NI 6507/NI 6508
- PCI-DIO-96
- PXI-6508
- DAQPad-6507 for USB
1
- DAQPad-6508 for USB
1
- PC-DIO-96
1
USB devices for Windows 2000/Me/98 only
Real-Time
See page 142
NI Application Software
• LabVIEW
• Measurement Studio
Operating Systems
• Windows 2000/NT/Me/9x*
• Mac OS**
Applications
• Interface to parallel digital
I/O peripherals
• Monitoring and control of switches,
relays, actuators, lights, and motors
• BCD-compatible panel meters and
test equipment
Accessories
See page 338
* Visit ni.com/info and enter winxp for the
latest operating system information
**Not for all hardware
NI 650x
Low-Cost Digital I/O 24 or 96 Lines, 5 V TTL/CMOS
INFO CODES
For more information
or to order products
online, visit ni.com/info
and enter:
pci6503
daqcarddio24
pcidio24
pcidio96
pxi6508
daqpad6507
daqpad6508
pcdio96
BUY ONLINE!
Digital Maximum Onboard Logic Handshaking Pattern
Family Bus I/O Lines Rate Memory Level Isolation I/O I/O Messaging Triggering
PCI,
NI 6503 PCMCIA, 24 Unstrobed – 5 V TTL/CMOS – ✓
1
– ✓ –
ISA I/O
NI 6507 PCI,
NI 6508 PXI/CPCI, 96 Unstrobed – 5 V TTL/CMOS – ✓
1
– ✓ –
USB, ISA I/O
1
Rates may depend on application, computer, software. See page 344 for more information.
Table 1. NI 650x Specifications Overview (see page 344 for detailed specifications)
Device Connector
PCI-6503 50-pin, see Figure 3
PC-DIO-24
DAQCard-DIO-24 27-pin; cable adapts it to the 50-pin connector shown in Figure 3
NI 6508 devices 100 pin; see Figure 2
Onboard screw terminals for all I/O signals and strain relief for
DAQPad-6507 ruggedized wiring. The DAQPad-6507 does not need
additional cables or external termination accessories.
Table 2. Digital Connectors
Comentarios a estos manuales